Cisco Cisco TelePresence Video Communication Server Expressway
Cisco VCS Control and Cisco VCS Expressway configuration
Cisco VCS Control and Cisco VCS Expressway
configuration
configuration
Step 1: Initial configuration
Assuming the Cisco VCS is in the factory delivered state; follow the Initial configuration steps
described in the Video Communications Server Getting Started Guide (version X5.1 or later) to
configure the Cisco VCS basic network parameters:
described in the Video Communications Server Getting Started Guide (version X5.1 or later) to
configure the Cisco VCS basic network parameters:
LAN1 IP (IPv4 or IPv6) address
Subnet mask (if using IPv4)
Default Gateway IP address (IPv4 or IPv6)
Note: Cisco VCSs require static IP addresses (they will not pick up an IP address from a DHCP
server).
server).
The initial configuration can be performed in one of three ways:
using a serial cable
via the front panel of the Cisco VCS
via the default IP address of 192.168.0.100
Refer to the “Initial configuration” section in the Cisco VCS Getting Started Guide for details.
Note: This deployment guide is based on configuration using the web interface. If you cannot access
the Cisco VCS using the web interface after completing the initial configuration (assigning the IP
address), speak to your network administrator.
the Cisco VCS using the web interface after completing the initial configuration (assigning the IP
address), speak to your network administrator.
The follow configuration values are used in the example deployment:
Cisco VCS Control
Cisco VCS Expressway
LAN1 IPv4 address
Use 10.0.0.2
Use 192.0.2.2
IPv4 gateway
Use 10.0.0.1
Use 192.0.2.1
LAN1 subnet mask
Use 255.255.255.0
Use 255.255.255.0
Cisco VCS Deployment Guide: Basic Cisco VCS configuration – Cisco VCS Control with
Cisco VCS Expressway
Cisco VCS Expressway
Page 9 of 44