Cisco Cisco TelePresence Video Communication Server Expressway
Introduction
Introduction
This document describes how to configure a single Cisco TelePresence Video Communication
Server (Cisco VCS) control platform for use in a basic video infrastructure deployment.
Server (Cisco VCS) control platform for use in a basic video infrastructure deployment.
The following diagram represents an example network environment into which the Cisco VCS Control
is being integrated. The example network names and addresses are used in the configuration steps
throughout this document.
is being integrated. The example network names and addresses are used in the configuration steps
throughout this document.
System name: myvcs
Domain name server (DNS):
10.0.0.1
Domain name: example.com
Local host name: myvcs
Network time protocol server (NTP):
myntpserver.example.com
Tandberg management server (TMS):
mytms.server.example.com
System log server (SYSLOG):
myloggingserver.example.com
IP network
Prerequisites
Before starting the system configuration, make sure you have access to:
the Cisco VCS Administrator Guide and Cisco VCS Getting Started Guide (for reference
purposes)
purposes)
a Cisco VCS Control running version X5 or later
a PC connected via Ethernet to a LAN which can route HTTP(S) traffic to the Cisco VCS
a web browser running on the PC
a serial interface on the PC and cable (if the initial configuration (Step 2) is to be performed using
the serial interface of the Cisco VCS)
the serial interface of the Cisco VCS)
Cisco VCS Deployment Guide: Single Cisco VCS Control – Basic Configuration
Page 3 of 27