Cisco Cisco TelePresence Video Communication Server Expressway
Upgrade an X6.0, X6.1, X7.0 or X7.0.n cluster to an X7.0.n cluster
Cisco VCS Deployment Guide: Cluster creation and maintenance (Cisco VCS X7.0.n)
Page 17 of 63
system>. This displays an activity log. Refresh this web page (button bottom left of this page) until
the Activity Event completed successfully is reported.
the Activity Event completed successfully is reported.
After the upgrade
If Cisco TMS is being used, verify the correct operation of TMS Agent by running TMS agent
diagnostics:
diagnostics:
1. Log into Cisco TMS.
2. Go to Administrative Tools > TMS Agent Diagnostics.
3. In the TMS Agent Browser panel on the left side of the page, select Local TMS Agent.
4. Click Run All Diagnoses to run the diagnostic tests on the Local TMS Agent.
5. For each Cisco VCS peer:
a. In the TMS Agent Browser panel on the left side of the page, expand the Clustered VCSs
folder and cluster folder and select the Cisco VCS peer.
b. Click Run All Diagnoses to run the diagnostic tests on the VCS peer.
Note: If authentication is intentionally enabled on the Cisco VCS, ignore the warning ‘verify that
authentication is disabled on the VCS’
authentication is disabled on the VCS’
If all tests are successful (all green check marks), proceed with the instructions below.
If any errors are found (a red ‘X’ will appear against failing tests), do not proceed further with this
upgrade, but contact your Cisco Authorized Service Provider for further assistance to resolve the
issues identified.
upgrade, but contact your Cisco Authorized Service Provider for further assistance to resolve the
issues identified.
Check cluster status
On each Cisco VCS (including the master):
1. Go to the Clustering page (VCS Configuration > Clustering).
•
Cluster database status should show SUCCEEDED.
•
VCS system configuration replication status should show Last synchronization result
SUCCEEDED.
SUCCEEDED.
2. If replication with Cisco TMS is enabled:
a. Select the link “View TMS Agent replication status”.
b. Check that the top line of the TMS Agent replication status report reports Replication
Enabled.
Upgrading an X6.0, X6.1 or X7.0 cluster to an X7.0.n cluster is now complete.