Cisco Cisco DWDM Transceiver Modules 설치 가이드

To install a GBIC transceiver module, follow these steps:

Remove the GBIC transceiver from its protective packaging.

Check the label on the GBIC transceiver to verify that the GBIC transceiver is the correct model for your 
network.

Grip the sides of the GBIC transceiver with your thumb and forefinger, and carefully align the GBIC 
transceiver with the module GBIC socket opening.

Carefully insert the GBIC through the socket flap and slide it into the module GBIC socket. (See 

 for optical GBICs or 

 for copper GBICs.) Continue sliding the GBIC transceiver into 

the socket until you hear a click which indicates that the GBIC is locked into the socket.

You must insert the GBIC straight into the socket (either horizontally or vertically, depending 
on the orientation of the socket). If you do not install the GBIC correctly or you use excessive 
force, you will damage the GBIC or the socket.

GBICs are keyed to prevent incorrect insertion.

For optical GBIC transceivers, before removing the dust plugs and making any optical connections, 
observe the following guidelines:

Always keep the protective dust plugs on the unplugged fiber-optic cable connectors and the 
transceiver optical bores until you are ready to make a connection.

Always inspect and clean the SC connector end-faces just before making any connections. Refer 
to the Tip on this page for a pointer to a fiber-optic inspection and cleaning white paper.

Always grasp the SC connector housing to plug or unplug a fiber-optic cable.

Remove the dust plugs from the network interface cable SC connectors. Save the dust plugs for future 
use.

Inspect and clean the SC connector’s fiber-optic end-faces. Refer to the Tip below for a pointer to a 
fiber-optic inspection and cleaning white paper.

For complete information on inspecting and cleaning fiber-optic connections, refer to the white-paper 
document at this URL: 

Remove the dust plugs from the GBIC transceiver optical bores.

The Read-Only WDM GBIC (WDM-GBIC-REC=) has only one optical bore (receive).

Immediately attach the network interface cable SC connector to the GBIC transceiver.

To connect 1000BASE-T GBIC transceivers to a copper network, follow these substeps: