Cisco Cisco VN 2900 Network Adaptation Interface 설치 가이드

Connecting Voice Interface Cards to the Network

Foreign Exchange Station (FXS) Interface Cards

OL-12847-01

Figure 2

2-Port FXS Card Front Panel (VIC2-2FXS)

Figure 3

4-Port FXS/DID Card Front Panel (VIC-4FXS/DID)

Connecting FXS Cards

Use a standard straight-through RJ-11 modular telephone cable to connect a VIC-2FXS,
VIC-4FXS/DID, or VIC2-2FXS to a telephone or fax machine.

Warning

This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call.

Warning

For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection: FXS.

Note

Ports on this interface card are colored gray.

Step 1

Confirm that the router is still turned off.

Step 2

Connect one end of the straight-through RJ-11 cable to an RJ-11 port on the card. (See

Figure 4

89041

VIC2-

2FXS

SEE MANUAL BEFORE INSTALLATION

IN USE

65683

VIC
4FXS/DID

IN USE