Cisco Cisco MeetingTime 빠른 설정 가이드
Configuring Call Control for Cisco Unified MeetingPlace
How to Configure Call Control for Voice Conferencing
3
Configuring Cisco Unified Communications Manager 6.x or a Later Release:
SIP Trunk to Cisco Unified MeetingPlace
SIP Trunk to Cisco Unified MeetingPlace
Before You Begin
•
Complete the
.
•
We recommend that you configure a Calling Search Space in Cisco Unified
Communications Manager that does the following:
Communications Manager that does the following:
–
Allows dial-out calls to meeting participants and the help desk
–
Prevents toll fraud by blocking unwanted dial-out calls, for example, to international or
premium-rate telephone numbers.
premium-rate telephone numbers.
See the Administration Guide for your release of Cisco Unified Communications Manager at
•
We recommend that you create a SIP trunk security profile in Cisco Unified
Communications Manager specifically for Cisco Unified MeetingPlace.
Communications Manager specifically for Cisco Unified MeetingPlace.
See
in the
module.
•
If you want to prevent conference disruption by music when a user places a call on hold, then
complete the
complete the
task in the
module.
•
You perform this task in the Cisco Unified Communications Manager Administration pages.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Procedure
Step 1
Go to http://ccm-server/, where ccm-server is the fully-qualified domain name or IP address of the
Cisco Unified Communications Manager server.
Cisco Unified Communications Manager server.
Step 2
Log in with your Cisco Unified Communications Manager administrator username and password.
Step 3
Select Device > Trunk.
Step 4
Select Add New.
Step 5
In the Trunk type field, select SIP Trunk.
Step 6
Select Next.
Step 7
Configure the fields described in
Table 1
.