Cisco Cisco E-Mail Manager Unity Integration Option 기술 참조
26
NEC PG Setup
4.1. Preparing for the Setup
The NEC PG is an OAI application and it requires the installation of NEC’s
Open Application Interface (OAI) NT API Libraries. Obtain a setup disk
from the NEC to install the libraries and DLLs that are required to interface
to the NEC-2400 and NEC-2000 switches.
Open Application Interface (OAI) NT API Libraries. Obtain a setup disk
from the NEC to install the libraries and DLLs that are required to interface
to the NEC-2400 and NEC-2000 switches.
In addition, NEC provides a security device (dongle) that must be installed
in the PG’s parallel port, along with a serial number and key that must be
entered during the NEC library setup. The PG setup will check for the
installation of the NEC library, and will block completion of the PG setup if
NEC library installation is not complete.
in the PG’s parallel port, along with a serial number and key that must be
entered during the NEC library setup. The PG setup will check for the
installation of the NEC library, and will block completion of the PG setup if
NEC library installation is not complete.
The PG setup disk also contains a copy of the NEC library setup; however,
the dongle, serial number, and security key must be obtained from the NEC.
To fake installation of the NEC library for the purposes of running a PG with
the ACD simulator, the following key may be defined in the registry:
the dongle, serial number, and security key must be obtained from the NEC.
To fake installation of the NEC library for the purposes of running a PG with
the ACD simulator, the following key may be defined in the registry:
HKLM\SOFTWARE\NECAM\OAI Platform\Serial
Numbers\OAIDLL\1#OAIDLL#RUN
Numbers\OAIDLL\1#OAIDLL#RUN
4.2. Configuring the PG in Web Setup Tool
Follow the steps below to configure the PG in the Web Setup Tool.
1. Begin with the Web Setup Tool by selecting a Unified ICM Instance
and then Add (to add a PG) or Edit (to edit an existing PG)
Figure 5: Web Setup Tool Screen