Cisco Cisco Edge 340 Digital Media Player 설치 가이드

Mounting the Kit Assembly (Display Mount) for Cisco Edge 340 Series

78-21288-01

Installation Scenarios

Figure 1

ACC-E340-M-D Assembled for Secure Mounting to a VESA-Compliant Display

Note

To fasten an LCD-mount plate to the LCD mount support bracket, use screw No. 2 with washer No. 3.
For information about these screws, see

Table 1 on page 2

Before You Begin

•

The fasteners for this scenario should be number 1, 2, and 3. For information about these fasteners,
see

Table 1 on page 2

. In addition, you will be using screws from the installation kit for your

third-party VESA bracket.

•

To learn which fabricated parts to use, find the column that describes this scenario in

Table 2 on

page 3

Procedure

Step 1

Place the LCD mount support bracket on a flat surface, such as a table or workbench. Its threaded bores
should touch the flat surface.

Step 2

Place the back plate on the bracket so that both of the following statements are true:

•

The threaded studs on the back plate should point at you.

•

The curved edge of the back plate is pointing away from the back of the bracket.

Step 3

Make sure that the bores in the back plate are aligned with bores in the bracket.

Step 4

Thread a No. 2 screw through each bore in the back plate, and then through the corresponding bore in
the bracket. For information about this screw, see

Table 1 on page 2

Step 5

Place the front cover on a flat surface, such as a table or workbench. Its side supports should point at you.

390080