Cisco Headend System Release 2.7 설치 가이드
Appendix E
Perform a DNCS Upgrade in a Disaster Recovery Enabled Network
178
4023737 Rev C
Take Disaster Recovery Jobs Off Hold
Complete the following steps to take Disaster Recovery jobs off Hold.
1 Log in to the Active MC's Disaster Recovery GUI with the following credentials
1 Log in to the Active MC's Disaster Recovery GUI with the following credentials
Username = dradmin
Password = dradmin
2 In the Synchronization Status block, select Near Real-Time Sync.
3 Under the Action column on the extreme right side of the GUI, select Restart.
4 On the left navigation panel, select DBDS Status.
5 In the Synchronization Status block, select Periodic Sync.
6 Under the Action column on the extreme right side of the GUI, select Restart.
7 On the left navigation panel, select DBDS Status.
8 In the Maintenance Status block, select Audit.
9 Under the Action column on the extreme right side of the GUI, select Restart.
10 On the left navigation panel, select DBDS Status.
11 In the Maintenance Status block, select Backup Primary DNCS.
12 Under the Action column on the extreme right side of the GUI, select Restart.
13 On the left navigation panel, select DBDS Status.
14 In the Maintenance Status block, select Backup Standby DNCS.
15 Under the Action column on the extreme right side of the GUI, select Restart.
3 Under the Action column on the extreme right side of the GUI, select Restart.
4 On the left navigation panel, select DBDS Status.
5 In the Synchronization Status block, select Periodic Sync.
6 Under the Action column on the extreme right side of the GUI, select Restart.
7 On the left navigation panel, select DBDS Status.
8 In the Maintenance Status block, select Audit.
9 Under the Action column on the extreme right side of the GUI, select Restart.
10 On the left navigation panel, select DBDS Status.
11 In the Maintenance Status block, select Backup Primary DNCS.
12 Under the Action column on the extreme right side of the GUI, select Restart.
13 On the left navigation panel, select DBDS Status.
14 In the Maintenance Status block, select Backup Standby DNCS.
15 Under the Action column on the extreme right side of the GUI, select Restart.