Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Chapter 4 Front Panel Operation
94
78-4039426-01 Rev D
Menu Item
Description
Parameters
Dst Port
This selects the destination
port number.
port number.
1 to 65535
Note: If you selected RTP for MOIP, you
must select an even destination port number.
must select an even destination port number.
SrcPort
This selects the source UDP
port number.
port number.
0 to 65535
Send SAP
This selects whether to send
Session Announcement
Protocol (SAP) messages.
Session Announcement
Protocol (SAP) messages.
Yes or No
SAP ID
This selects whether to send
the user configured string,
defined in the User SAP
Identifier, as the output
stream name in a SAP
announcement.
the user configured string,
defined in the User SAP
Identifier, as the output
stream name in a SAP
announcement.
Yes or No
User SAP
Identifier
Identifier
This is the SAP string.
Note: If the SAP ID is set to
No, the User SAP
Identifier is not used.
No, the User SAP
Identifier is not used.
Up to 49 characters
TS Out - DPM
To view the DPM menu from the TS Out menu, press the RIGHT arrow key. The
DPM menu provides access to functionality associated with Global and ASI outputs.
DPM menu provides access to functionality associated with Global and ASI outputs.
The DPM menu allows you to groom functionality on a program basis where
individual service PID modifications are provided on a limited scale.
individual service PID modifications are provided on a limited scale.
Use the digital program mapping features to:
configure the transport output bit rate
configure the output mode for a program entry
configure the service and PID output settings in a program entry
Note: Any changes made to the ASI DPM values will automatically change the TS
Output mode to Full DPM Control.
Output mode to Full DPM Control.