Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Chapter 5 Web GUI Setup and Monitoring
132
78-4039426-01 Rev D
Setting up the ASI Input
1 From the user interface of the D9824, click Input > Input Setup. The Input Setup
page is displayed.
2 Click on the ASI tab.
3 Select Use ASI Input to tune to the ASI input.
Note: Setting a new input to be active will deactivate the currently active input.
4 The ASI Input Status section displays the current RF status. The following table
describes the ASI Input Status information displayed:
Parameter
Description
Active Input
Indicates the currently selected input source (RF1, RF2, RF3,
RF4, or ASI).
RF4, or ASI).
Signal Status
Indicates whether the input signal is locked.
Locked - Indicates the receiver is locked to a carrier
with no valid content.
with no valid content.
Lock+Sig - Indicates the receiver is locked to a carrier
with valid content.
with valid content.
No Lock - Indicates the receiver is not locked to a
carrier.
carrier.
Input Rate (Mbps)
Displays the bit rate of the input transport stream, in Mbps.
ASI Link
Indicates whether there is a transport stream link error (Error,
Ok, or N/A).
Ok, or N/A).