Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드

 

158 

78-4039426-01 Rev D 

1  From the user interface of the D9824, click Audio & Video > Audio & Video > 

Audio Decoding. The Audio Decoding page is displayed. 

 

2  There are two audio settings. It allows you to configure the two balanced audio 

outputs on the rear panel (Audio 1 and Audio 2), known in the Web GUI as 1 
and 2, respectively. 

3  Select the PMT Source for the audio channel (None, AUD1 to AUD64). 
4  Set the Audio Mode, which sets the output mixing. 

Select Stereo (Left and Right are passed directly through to Left and Right), R-
Mono (Right is passed to both the Left and Right), L-MONO (Left is passed to 
both the Left and Right), or Mixed (Left is passed to both the Left and Right, and 
Right is passed to both the Left and Right). 

5  Set the AC3 Compression mode to use if the output is compressed Dolby Digital 

audio. The selections are Line Mode, Custom 1, Custom 0 or RF Mode. RF Mode 
is recommended for analog cable modulators. 

6  Left Attenuation is the volume adjustment for the Left audio channel. You can 

select a value in the range from -6.0 dB to +6.0 dB, in increments of 0.5 dB. 

7  Right Attenuation is the volume adjustment for the Right audio channel. You 

can select a value in the range from -6.0 dB to +6.0 dB, in increments of 0.5 dB. 

8  The Audio Status section displays the current audio settings. The following table 

describes the audio status information: 

Audio   

Displays the current audio deocder status.