Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Setting up Audio and Video Information
78-4039426-01 Rev D
163
Setting up Cue Tones
1 From the user interface of the D9824, click Audio & Video > Other Outputs,
expand Cueing and then click Cue Tone. The Cue Tone page is displayed.
2 The Sequence Number lists the tone sequences. The receiver supports up to 16
tone sequences. You can configure the state, tones, mode, and delay for each tone
sequence.
sequence.
3 Set the Sequence State (Enabled or Disabled) of the current tone sequence. When
disabled, no cue tone is output.
4 In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5 Select the tone Sequence Mode.
5 Select the tone Sequence Mode.
Select * for start tone, # for the end tone, and */# for the start and end tones. The
end tone is signaled after waiting the time specified in Sequence Delay.
end tone is signaled after waiting the time specified in Sequence Delay.
6 If the Sequence Mode was set to */# (Start/Stop), set the Sequence Delay, in
seconds, between the start and stop sequences. You can enter a value in the
range from 1 to 255. The default is 30.
range from 1 to 255. The default is 30.
7 Click Apply.