Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
3
Release Notes for Cisco Aironet 350, 1100, 1130AG, 1200, and 1230AG Series Access Points for Cisco IOS Release 12.3(2)JA6
OL-10201-01
System Requirements
IOS (tm) C1200 Software (C1200-K9W7-M), Version 12.2(15)JA
Copyright (c) 1986-2004 by Cisco Systems, Inc.
On access points running IOS software, you can also find the software version on the System Software
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Upgrading to a New Software Release
For instructions on installing access point software:
Step 1
Follow this link to the Cisco home page:
http://www.cisco.com
Step 2
Click Technical Support and Documentation. The Technical Support and Documentation page
appears.
appears.
Step 3
Click Documentation.
Step 4
Click Wireless. The Wireless Support Resources page appears.
Step 5
Scroll down to the Wireless LAN Access section.
Step 6
Select the access point model for which you need the information. The Introduction page for the model
you selected appears.
you selected appears.
Step 7
Under the Configure section, click Configuration Guides. A list of configuration documents appears.
Step 8
Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.3(2)JA.
Step 9
Navigate to the Managing Firmware and Software chapter.
For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on
Cisco.com:
Cisco.com:
An IOS Upgrade Planner is available on cisco.com for registered users. Follow this link to access it:
Disable Radios to Prevent Unexpected Reboot When Upgrading System Software
If your access point runs Cisco IOS Release 12.2(11)JA, 12.2(11)JA1, or 12.2(11)JA2, your access point
might unexpectedly reboot after you upgrade to a later Cisco IOS Release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
might unexpectedly reboot after you upgrade to a later Cisco IOS Release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
Follow these steps to disable the radio interfaces using the web-browser interface:
Step 1
Browse to the Network Interfaces: Radio Settings page. shows the top portion of the Network Interfaces:
Radio Settings page.
Radio Settings page.