Cisco Cisco Tunnel Terminating Gateway (TTG)
Global Configuration Mode Commands (L-S)
qos l2-mapping-table ▀
Command Line Interface Reference, StarOS Release 18 ▄
5501
qos l2-mapping-table
Creates or modifies a Level 2 mapping table and enters the QoS L2 Mapping Configuration Mode to map internal QoS
priority.
priority.
Product
ePDG
HSGW
P-GW
SAEGW
S-GW
Privilege
Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local] host_name (config)#
Syntax
qos l2-mapping-table { name map_table_name | system-default }
no qos l2-mapping-table name map_table_name
no
Deletes the specified L2 mapping table.
Important:
The system-default table ca not be deleted. Only named tables that were previously created using this
CLI command can be deleted.
name map_table_name
Specifies the name of an internal table from which to map QoS to L2 values.
map_table_name
must be an alphanumeric string of 0 through 80 characters.
system-default
Configure the system default mapping.
Usage
Use this command to create or modify an L2 mapping table and enter the QoS L2 Mapping Configuration
Mode, which is used to map internal QoS values to L2 values.
Entering this command results in the following prompt:
Mode, which is used to map internal QoS values to L2 values.
Entering this command results in the following prompt: