Cisco Cisco ASA for Nexus 1000V Series Switch 기술 매뉴얼
ASA 7.2(2): SSL VPN Client (SVC) for Public
Internet VPN on a Stick Configuration Example
Internet VPN on a Stick Configuration Example
Document ID: 100894
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
ASA 7.2(2) Configurations Using ASDM 5.2(2)
ASA 7.2(2) CLI Configuration
Establish the SSL VPN Connection with SVC
Verify
Troubleshoot
Related Information
ASA 7.2(2) CLI Configuration
Establish the SSL VPN Connection with SVC
Verify
Troubleshoot
Related Information
Introduction
This document describes how to set up an Adaptive Security Appliance (ASA) 7.2.2 to perform SSL VPN on
a stick. This setup applies to a specific case in which the ASA does not allow split tunneling and users connect
directly to the ASA before they are permitted to go to the Internet.
a stick. This setup applies to a specific case in which the ASA does not allow split tunneling and users connect
directly to the ASA before they are permitted to go to the Internet.
Note: In ASA version 7.2.2, the intra−interface keyword of the same−security−traffic permit configuration
mode command allows all traffic to enter and exit the same interface (not just IPsec traffic).
mode command allows all traffic to enter and exit the same interface (not just IPsec traffic).
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
The hub ASA Security Appliance needs to run version 7.2.2
•
Cisco SSL VPN Client (SVC) 1.x
Note: Download the SSL VPN Client package (sslclient−win*.pkg) from Cisco Software Download
(registered customers only) . Copy the SVC to the flash memory on the ASA. The SVC is to be
downloaded to the remote user computers in order to establish the SSL VPN connection with the
ASA. Refer to Installing the SVC Software section of the Cisco Security Appliance Command Line
Configuration Guide, Version 7.2 for more information.
(registered customers only) . Copy the SVC to the flash memory on the ASA. The SVC is to be
downloaded to the remote user computers in order to establish the SSL VPN connection with the
ASA. Refer to Installing the SVC Software section of the Cisco Security Appliance Command Line
Configuration Guide, Version 7.2 for more information.
•
Components Used
The information in this document is based on these software and hardware versions: