Cisco Cisco IPS 4255 Sensor 릴리즈 노트

Release Notes for Cisco Intrusion Prevention System 5.1(8)E2

OL-20154-01

Before Upgrading to Cisco IPS 5.1(8)E2

For More Information

For instructions on how to access these files on Cisco.com, see

Obtaining Software on Cisco.com,

page 9

Upgrading the IDS-4210 Memory

IDS-4210, IDS-4210-K9, and IDS-4210-NFR must have 512 MB of RAM to support Cisco IPS 5.x. If
you are upgrading an existing IDS-4210, IDS-4210-K9, or IDS-4210-NFR to 5.x, you must insert one
additional 256-MB DIMM (part number IDS-4210-MEM-U) to upgrade the memory to the required 512
MB minimum.

Note

Do not install an unsupported DIMM. Doing so nullifies the warranty.

Caution

Follow proper safety procedures when performing these steps by reading the safety warnings in

Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System 4200 Series
Appliance Sensor

To upgrade the memory, follow these steps:

Step 1

Step 2

Prepare the appliance to be powered off:

sensor# reset powerdown

Wait for the power down message before continuing with Step 3.

Note

You can also power down the sensor from IDM or ASDM.

Step 3

Power off the appliance.

Step 4

Remove the power cord and other cables from the appliance.

Step 5

Place the appliance in an ESD-controlled environment.

Step 6

Remove the chassis cover by unscrewing the screw on the front of the cover and sliding the cover straight
back.

IDS module for Catalyst 6K

WS-SVC-IDSM2-

IDS network module

IPS-NM-CIDS-

AIP-SSM

IPS-SSM-

Table 3

Platform Identifiers (Continued)

Sensor

Identifier