Cisco Cisco TelePresence Video Communication Server Expressway
Enabling endpoints registered on Cisco VCS Control to call endpoints registered on CUCM
Cisco VCS Deployment Guide: CUCM v6.1, 7 and 8 with Cisco VCS X7 using a SIP trunk
Page 21 of 54
mode
Peer 1 address
IP address of CUCM, or the domain of CUCM.
Zone profile (Advanced
section)
section)
Select Cisco Unified Communications Manager.
See ‘Appendix 8 – Parameters set by the ‘Cisco Unified Communications
Manager’ Advanced Zone profile’ for details on what is configured by this
setting.
See ‘Appendix 8 – Parameters set by the ‘Cisco Unified Communications
Manager’ Advanced Zone profile’ for details on what is configured by this
setting.
Note: The Cisco VCS Control is to use SIP over TCP to communicate with the CUCM. If you want to
use TLS, complete the configuration as described here for TCP and then refer to Appendix 10 –
Connecting Cisco VCS to CUCM using TLS (rather than TCP).
use TLS, complete the configuration as described here for TCP and then refer to Appendix 10 –
Connecting Cisco VCS to CUCM using TLS (rather than TCP).
4. Click Create zone.
Create a search rule to route calls to the CUCM neighbor zone
1. Go to
VCS configuration > Dial plan > Search rules
.
2. Click New.