Cisco Cisco TelePresence Video Communication Server Expressway
Enabling endpoints registered on CUCM to call endpoints registered on the Cisco VCS Control
Cisco VCS Deployment Guide: CUCM v6.1, 7 and 8 with Cisco VCS X7.1 using a SIP trunk
Page 25 of 53
3. Configure the fields as follows:
Description
CUCM to registered devices
Priority
5 (for example; note that the priority of this transform should be
above any transforms that should be applied for searching local
and neighbor zones)
above any transforms that should be applied for searching local
and neighbor zones)
Pattern type
Regex
Pattern string
For example: (0118912)?(4\d{3})@%ip%(:.*)?
Pattern behavior
Replace
Replace string
0118912\2@vcs.domain
State
Enabled
4. Click Create transform.
Ensure that VCS stays in the signaling path for calls with CUCM
To handle calls using GRUU, where the contact address is not an IP address, and allow call signaling
to be routed properly where the contact IP is non-routable by CUCM (such as when Multiway is in use
and the MCU is registered to the VCS), VCS needs to stay in the signaling path. This can be
configured by the zone profile, as follows.
to be routed properly where the contact IP is non-routable by CUCM (such as when Multiway is in use
and the MCU is registered to the VCS), VCS needs to stay in the signaling path. This can be
configured by the zone profile, as follows.
If VCS is version X7.0.n, go to the CUCM neighbor zone and:
a. Change the Advanced Zone profile from Cisco Unified Communications Manager to
Custom.
b. Set the parameters as documented in “Appendix 8 – Parameters set by the ‘Cisco Unified
c.
Set Call signaling routed mode to Always.
If VCS is version X7.1 or later, these settings are applied by default in the Cisco Unified
Communications Manager zone profile, so this does not need to be changed.
Communications Manager zone profile, so this does not need to be changed.