Cisco Cisco TelePresence Video Communication Server Expressway
Appendix 6 – Cisco TelePresence Multiway and CUCM
Cisco VCS Deployment Guide: CUCM v6.1, 7 and 8 with Cisco VCS X7.1 using a SIP trunk
Page 44 of 53
Appendix 6 – Cisco TelePresence Multiway and
CUCM
CUCM
To enable CUCM registered endpoints to be joined into a Multiway™ conference:
1. Ensure a zone profile with Call Signaling Routed Mode set to Always is in use on the Zone
towards the CUCM on the VCS.
2. Ensure that CUCM will route calls to VCS (using Route Patterns) which have the domain given by
the Multiway alias.
3. Ensure that CUCM is configured with “Redirect by Application” selected in the SIP profile used by
the SIP trunk to VCS.
VCS configuration
If Cisco VCS X7.0.n is in use, or a custom zone profile is in use, in Cisco VCS, go to the CUCM
neighbor zone and:
neighbor zone and:
1. Change the Advanced Zone profile from Cisco Unified Communications Manager to Custom.
2. Set the parameters as documented in “Appendix 8 – Parameters set by the ‘Cisco Unified
3. Ensure that Call signaling routed mode is set to Always.
CUCM configuration
Ensure that CUCM will route calls to VCS which have a video domain:
1. Follow the instructions in “Appendix 3 – Allow dialing to Cisco VCS domain from Cisco phones”.
In the SIP profile used by the SIP trunk to VCS, ensure that “Redirect by Application” is selected:
1. Go to
Device > Device Settings > SIP Profile
.
2. Select the check box by Redirect by Application.
3. Click Save.
4. Click Apply Config.
5. Click OK.
You can now test Multiway.