Cisco Cisco TelePresence Video Communication Server Expressway
Configuring the Cisco AM GW
Cisco VCS Deployment Guide: Microsoft OCS 2007 R2, Cisco VCS X6.1
and Cisco AM GW 1.0
and Cisco AM GW 1.0
Page 13 of 24
2. Configure the fields as follows:
Motion / sharpness
tradeoff
tradeoff
As required, e.g. Balanced
Default bandwidth
from AM GW
from AM GW
As required, e.g. 2.00 Mbit/s
Default bandwidth to
AM GW
AM GW
<same as transmit>
<other parameters>
As required
Note: Some endpoints and network equipment do not support as many codecs as the Cisco AM GW
can offer. For best interoperation it is recommended that at least one audio codec is left unselected in
the Audio codecs from Cisco AM GW and Audio codecs to Cisco AM GW sections.
can offer. For best interoperation it is recommended that at least one audio codec is left unselected in
the Audio codecs from Cisco AM GW and Audio codecs to Cisco AM GW sections.
Click Apply changes.
Resource settings
1. Go to the Resource settings page (Settings > Resource settings).
2. Configure the fields as follows:
Call capability
Allow HD – supports high definition video calls at up to 720p at 30fps
SD only – supports calls at up to w448p at 30fps
SD only – supports calls at up to w448p at 30fps
Note: The number of calls supported in the selected mode is shown.
This depends on the model of AM gateway you are using.
This depends on the model of AM gateway you are using.
3. Click Apply changes.
Note: If this setting is changed the Cisco AM GW will need to be shut down and restarted (see ‘Shut
down and restart Cisco AM GW’ on page14).
down and restart Cisco AM GW’ on page14).
Time
1. Go to the Time page (Settings > Time).