Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드
Installing the Cisco VCS
Powering on the Cisco VCS
1. Turn on the power switch on the back right of the unit (adjacent to the power cable). The system
will power up. If the unit does not start after 3 seconds, press the soft power button.
Wait until:
Wait until:
l
the green PWR LED on the front of the unit is a steady green color (it may flash briefly during
power up)
power up)
l
the red ALM LED on the front of the unit has gone out
l
the IP address is showing in the display panel on the front of the unit
If the red ALM LED flashes rapidly it indicates a hardware fault. Contact your local Cisco
representative. The yellow HDD LED indicates disk activity and may flicker during normal
operation, more so on a busy system.
representative. The yellow HDD LED indicates disk activity and may flicker during normal
operation, more so on a busy system.
Figure 1: Cisco VCS back view
VCS Getting Started Guide
Page 5 of 12