Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드
Remotely Connect to Serial Using the CIMC
Note:
For remote access to the serial port, you must enable Serial over LAN (SoL) on the CIMC. You can do so under
Server > Remote Presence > Serial Over LAN in the CIMC interface.
1.
On your chosen emulator, connect using SSH and enter the CIMC IP address to connect.
2.
Enter admin and password as the default username and password and press Enter.
3.
Type
connect host
and press Enter.
4.
You are now connected using serial and will see the login prompt
cisco login:
You can now proceed to configure the Cisco VCS.
Configure the Cisco VCS
If the system has just booted up, the terminal emulator program on the PC will display the Cisco VCS’s startup
information. After approximately four minutes you will get the login prompt. If the Cisco VCS was already on when you
connected the serial cable, press
information. After approximately four minutes you will get the login prompt. If the Cisco VCS was already on when you
connected the serial cable, press
Enter
to get the login prompt.
1.
Enter the username
admin
and press
Enter
.
2.
Enter the default password of
TANDBERG
and press
Enter
.
You will get the install wizard prompt:
Run install wizard [n]:
3.
Type
y
and press
Enter
.
4.
Follow the prompts given by the install wizard to specify the following:
—
The password you want to use for your admin account.
Note:
For security reasons you are advised to change the password from the default of
TANDBERG
.
—
Whether you want to use IPv4, IPv6 or Both .
—
The LAN 1 IP address of the Cisco VCS.
—
The LAN 1 IPv4 subnet mask of the Cisco VCS (if you have selected IPv4).
—
The IP address of the default gateway of the Cisco VCS.
—
The Ethernet speed.
Note:
Use the default value of
Auto
.
—
Whether you want to use SSH to administer the Cisco VCS.
5.
After the wizard is finished the following message will appear:
Setting other settings...OK.
The system must be restarted for new
settings to take effect..
settings to take effect..
You will get a restart prompt:
Restart Now?
Type
y
and press
Enter
.
6.
After it has rebooted, the Cisco VCS is ready to use. You can access the Cisco VCS's web interface using the
IP address assigned to the LAN 1 Ethernet port.
IP address assigned to the LAN 1 Ethernet port.
Note:
For security reasons you are advised to change the password for the
(if you have not
already done so) and the
from the default of TANDBERG.
13
Cisco Video Communication Server CE1100 Appliance Installation Guide
Configure