Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드
Configure
This section describes the different ways you can connect to the Cisco VCS and perform the initial configuration.
Connect to the Cisco VCS
Before you can use the Cisco VCS, you must configure its IPv4 and/or IPv6 address, subnet mask and default
gateway. Consult your network administrator for information on which addresses to use. Note that the Cisco VCS
must use a static IP address.
gateway. Consult your network administrator for information on which addresses to use. Note that the Cisco VCS
must use a static IP address.
Note:
An additional IP address is required if the Cisco Integrated Management Controller (CIMC) tool is used. It can be
a static IP address or assigned using DHCP.
For initial configuration, use any of these methods:
■
Connect a PC to the Cisco VCS using a serial cable (see
followed by
).
■
Connect a monitor and keyboard directly into the unit (see
followed by
).
■
Connect using the CIMC port ( see
followed by
).
■
If your network is set up to allow it, use a web browser to connect to the default IP address of 192.168.0.100
(see
(see
).
Figure 1 Rear Panel Showing Ports
1
LAN 1 (left-hand SFP port)
2
LAN 2 ( right-hand SFP port)
3
Modular LAN-on-motherboard (MLOM) card slot
4
USB 3.0 port
5
USB 3.0 port
6
CIMC port
7
Serial Port (RJ-45 connector)
Table 3 Rear Panel Ports
10
Cisco Video Communication Server CE1100 Appliance Installation Guide
Configure