Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드
Rear View
Below is an illustration of the unit's rear view and a list of the LEDs and components available.
Figure 4 Rear View of the Cisco TelePresence Video Communication Server Unit
1
LAN 1
2
LAN 2
3
Modular LAN-on-motherboard (mLOM) card slot
4
USB 3.0 port
5
USB 3.0 ports
6
1-Gb Ethernet dedicated management port
7
Serial port (RJ-45 connector)
8
LAN 3
9
LAN 4
10
VGA video connector
11
Rear unit identification button/LED
12
Power supplies (up to two, redundant as 1+1)
Definitions of LED States
For the definitions of the LED states see
Reset from the Internal Recovery Partition (IRP)
The Cisco VCS CE1100 appliance comes pre-installed with an SD card that you can use to complete a factory reset
of your configuration. You must reset the SD card and enable the virtual drive before proceeding with the factory
reset using the KVM console in the Cisco Integrated Management Controller (CIMC). Once the reset has been
complete, ensure that you disable the virtual drive again.
of your configuration. You must reset the SD card and enable the virtual drive before proceeding with the factory
reset using the KVM console in the Cisco Integrated Management Controller (CIMC). Once the reset has been
complete, ensure that you disable the virtual drive again.
Note:
You must set up and access the CIMC to instigate a factory reset. See
17
Cisco Video Communication Server CE1100 Appliance Installation Guide
Troubleshooting