Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드

다운로드
페이지 32
Potential 
issue area
What to look for
Network
Any network failure or locking causes a connection failure between the VM and the virtual network. 
Also, if using NFS or iSCSI, storage may cause application failures because the application cannot 
access the file system.
DNS
DNS server failures or communication failures between DNS and the VM server may cause the 
VMware application or the VM VCS application to fail.
vCenter 
Server
If vCenter is not operating properly, even though the VM VCS application is still up and running, you 
may lose connection to the VM VCS application from the network.
Host 
application
Check any critical alarms on the VM application for events on the host or application level (check the 
event information from vSphere Client).
Possible issues
VM image fails to boot
If the VM image fails to boot, check the VT (Virtualization Technology) setting in BIOS. This needs to be 
enabled for hosting VMs. If it is not set, set it and re-install ESXi then load the .ova file.
VCS application fails to start
Look at the /tmp/hwfail file – its content will indicate any violations in the installation.
For example, VCS reserves 3 virtual NICs – these are required in the VCS, do not try deleting one or more of 
them otherwise hwfail will be created and the VM  VCS will not run.
Configured NTP does not work
For NTP to work on VCS, the same NTP must also be configured on the VM host.
Guest console in vSphere 5 fails to run on some Microsoft platforms
When attempting to open a console screen from vSphere for the VM:
 
n
Error message: “The VMRC console has disconnected...attempting to reconnect.”
 
n
Screen remains black
The following operating systems are at risk:
 
n
Windows 7 64 bit – reported on VMware forum (
)
 
n
Windows Server 2008 R2 (64-bit) – found by use
Web page/IP address unreachable  after OVA deployment
This issue can be caused by a cache issue in the gateway switch. 
To resolve, access vCenter, go to the console and ping the gateway: ping <gateway_ip_address>.
Web page unreachable while taking snapshot
When taking a snapshot, the entire state of the virtual machine is stunned (paused) so snapshot files can be 
written to disk. 
To resolve, shut down the VM before taking snapshots.
Cisco TelePresence VCS on Virtual Machine Installation Guide (X8.6)     
Page 21 of 32
Appendix 1: Troubleshooting