Cisco Cisco TelePresence Video Communication Server Expressway 릴리즈 노트
Management Suite Provisioning Extension which requires TMS 13.2.x. See Cisco TMS Provisioning Extension
Deployment Guide for instructions about how to migrate.
Deployment Guide for instructions about how to migrate.
Existing OCS Relay Deployments
Cisco VCS X8.1 and later no longer supports OCS Relay integration with Microsoft Lync 2010 / OCS 2007 R2. If you
use OCS Relay you must migrate to using the Microsoft Interoperability B2BUA to route SIP calls between the Cisco
VCS and Microsoft infrastructure. See Cisco VCS and Microsoft Infrastructure Deployment Guide for information
about this deployment.
use OCS Relay you must migrate to using the Microsoft Interoperability B2BUA to route SIP calls between the Cisco
VCS and Microsoft infrastructure. See Cisco VCS and Microsoft Infrastructure Deployment Guide for information
about this deployment.
Existing Non-AES Build Installations
As of version X8.1, the software uses AES encryption. Prior to this, a version that used weaker encryption was
available. If you are upgrading to X8.1 or later (or another version that uses AES) from a version that used the weaker
encryption, you must perform a factory reset. Proceed as follows to ensure you can upgrade in future:
available. If you are upgrading to X8.1 or later (or another version that uses AES) from a version that used the weaker
encryption, you must perform a factory reset. Proceed as follows to ensure you can upgrade in future:
1.
Record all your software configuration details
2.
Upgrade the software with the AES-encryption version
All configuration will be lost
3.
Perform a factory reset
4.
Manually reconfigure the software
Upgrade Instructions
When maintenance mode is enabled on Cisco VCS, existing calls passing through it may be dropped. We recommend
that you upgrade Cisco VCS components while the system is inactive.
that you upgrade Cisco VCS components while the system is inactive.
If you are upgrading a Cisco VCS that uses clustering, device provisioning (Cisco TMSPE) or FindMe (with Cisco TMS
managing Cisco VCS), you must follow the directions in Cisco VCS Cluster Creation and Maintenance Deployment
Guide.
managing Cisco VCS), you must follow the directions in Cisco VCS Cluster Creation and Maintenance Deployment
Guide.
Follow the procedure below for upgrading Cisco VCS to X8.8, only if all of the following apply:
■
The Cisco VCS is not part of a cluster
■
Device provisioning is not in use
■
Cisco TMS is not managing the Cisco VCS
■
Cisco VCS is currently running X5.1.1 or later
To upgrade a Cisco VCS:
1.
Backup the Cisco VCS (Maintenance > Backup and restore).
You should backup your system before upgrading. If you later need to downgrade to an earlier release you will
have to restore a backup made against that previous release.
have to restore a backup made against that previous release.
If your system was delivered with X6.1 pre-installed, you must make some configuration changes before using
the backup process as described in the section below.
the backup process as described in the section below.
2.
Enable maintenance mode.
Log in to the Cisco VCS as admin (SSH or serial), and at a command prompt, type:
xConfiguration SystemUnit Maintenance Mode: On
Note that from X8.1 you can enable maintenance mode via the web interface (Maintenance > Maintenance
mode).
mode).
3.
Wait for all calls to clear and registrations to timeout.
—
If necessary, manually remove any calls that do not clear automatically (Status > Calls, click Select all and
then click Disconnect).
then click Disconnect).
—
If necessary, manually remove any registrations that do not clear automatically (Status > Registrations > By
device, click Select all and then click Unregister).
device, click Select all and then click Unregister).
15
Cisco TelePresence Video Communication Server Release Notes
Upgrading to X8.8