Cisco Cisco TelePresence Video Communication Server Expressway 릴리즈 노트
■
Cisco Jabber for Mac 9.6 or later
■
Cisco TelePresence endpoints/codecs running TC7.0.1 or later firmware
MRA Support for New Endpoints
The Cisco IP Phone 78/8800 Series endpoints are not yet officially supported via MRA, but they must be running
version 10.3.1 or later if you want to preview them with Mobile and Remote Access.
version 10.3.1 or later if you want to preview them with Mobile and Remote Access.
Interoperability
, where you can
also find interoperability test results for other Cisco TelePresence products.
Upgrade to X8.6
Prerequisites and Software Dependencies
Existing TMS Agent (Legacy Mode) Provisioning Deployments
Cisco VCS X8.1 and later no longer supports TMS Agent (legacy mode) provisioning. Before you upgrade to X8 or
later, if you are using TMS Agent (legacy mode) for provisioning you must first migrate to Cisco TelePresence
Management Suite Provisioning Extension which requires TMS 13.2.x. See Cisco TMS Provisioning Extension
Deployment Guide for instructions about how to migrate.
later, if you are using TMS Agent (legacy mode) for provisioning you must first migrate to Cisco TelePresence
Management Suite Provisioning Extension which requires TMS 13.2.x. See Cisco TMS Provisioning Extension
Deployment Guide for instructions about how to migrate.
Existing OCS Relay Deployments
Cisco VCS X8.1 and later no longer supports OCS Relay integration with Microsoft Lync 2010 / OCS 2007 R2. If you
use OCS Relay you must migrate to using the Microsoft Lync B2BUA to route SIP calls between the Cisco VCS and a
Microsoft Lync Server. See VCS and Microsoft Lync Deployment Guide for information about how to configure your
video network.
use OCS Relay you must migrate to using the Microsoft Lync B2BUA to route SIP calls between the Cisco VCS and a
Microsoft Lync Server. See VCS and Microsoft Lync Deployment Guide for information about how to configure your
video network.
Existing Non-AES Build Installations
As of version X8.1, the software uses AES encryption. Prior to this, a version that used weaker encryption was
available. If you are upgrading to X8.1 or later (or another version that uses AES) from a version that used the weaker
encryption, you must perform a factory reset. Proceed as follows to ensure you can upgrade in future:
available. If you are upgrading to X8.1 or later (or another version that uses AES) from a version that used the weaker
encryption, you must perform a factory reset. Proceed as follows to ensure you can upgrade in future:
1.
Record all your software configuration details
2.
Upgrade the software with the AES-encryption version
All configuration will be lost
3.
Perform a factory reset
4.
Manually reconfigure the software
Upgrade Instructions
When maintenance mode is enabled on Cisco VCS, existing calls passing through it may be dropped. We recommend
that you upgrade Cisco VCS components while the system is inactive.
that you upgrade Cisco VCS components while the system is inactive.
If you are upgrading a Cisco VCS that uses clustering, device provisioning (Cisco TMSPE) or FindMe (with Cisco TMS
managing Cisco VCS), you must follow the directions in Cisco VCS Cluster Creation and Maintenance Deployment
Guide.
managing Cisco VCS), you must follow the directions in Cisco VCS Cluster Creation and Maintenance Deployment
Guide.
8
Cisco TelePresence Video Communication Server Release Note