Cisco Cisco TelePresence Video Communication Server Expressway 릴리즈 노트
Introduction
Cisco TelePresence Video Communication Server X7.0.2 Software Release Notes
Page 5 of 32
Introduction
These release notes describe the features and capabilities included in the Cisco TelePresence Video
Communication Server (Cisco VCS) software version X7.0.2.
Communication Server (Cisco VCS) software version X7.0.2.
Upgrading to VCS X7.0.n
CAUTION: If you are upgrading a cluster, you must follow the directions in the X7.0.n “Cluster
Creation and Maintenance” Cisco VCS deployment guide (document D14367), otherwise the cluster
will not synchronize.
Creation and Maintenance” Cisco VCS deployment guide (document D14367), otherwise the cluster
will not synchronize.
There is a software dependency between VCS X7.n and TMS 12.6 or later. If you are running Cisco
TelePresence Management Suite (Cisco TMS) with Provisioning or FindMe, or your Cisco VCSs are
clustered and you want to upgrade your Cisco VCS to X7.0 or later, you must also upgrade Cisco
TMS to TMS 12.6 or later, see the table below.
TelePresence Management Suite (Cisco TMS) with Provisioning or FindMe, or your Cisco VCSs are
clustered and you want to upgrade your Cisco VCS to X7.0 or later, you must also upgrade Cisco
TMS to TMS 12.6 or later, see the table below.
Deployment using Provisioning, Clustering or FindMe
Software version
TMS 12.1
TMS 12.2
TMS 12.5
TMS 12.6 or later
X4.n
√
√
X
X
X5.0, X5.1.1
X
X
√
X
X5.2
X
X
X
√
X6.n
X
X
X
√
X7.n
X
X
X
√
Note: If you are running TMS 12.5 you must upgrade it to 12.6 or later before upgrading to VCS X7.n.
Note: You should backup your system before upgrading. If you later need to downgrade to an earlier
release you will have to restore a backup made against that previous release (see “Upgrading from
X6.1 to X7” for more information about backing up X6.1 systems).
release you will have to restore a backup made against that previous release (see “Upgrading from
X6.1 to X7” for more information about backing up X6.1 systems).
It is vital that you upgrade the Cisco VCS and Cisco TMS correctly – instructions for the upgrade are
documented in the ”Updating to” section of this document.
documented in the ”Updating to” section of this document.
Upgrading a non-clustered Cisco VCS to X7.0.n from X5.0 or earlier
If you are currently running VCS X5.0 or earlier you must first upgrade to X5.2 and then upgrade from
X5.2 to X7.0.n.
X5.2 to X7.0.n.
You can only upgrade directly to X7.0.n if you have version X5.1 or later.
Device authentication
Upgrades from release X5.2 or earlier to X7.0.n
If device authentication is not enabled when the Cisco VCS is upgraded to X7.0.n, the upgrade
process will configure all zones and subzones (except the default zone) on the Cisco VCS with
authentication set to ‘Treat as authenticated’. This ensures that:
process will configure all zones and subzones (except the default zone) on the Cisco VCS with
authentication set to ‘Treat as authenticated’. This ensures that:
CPL continues to work as expected
Caller ID can be set to the FindMe ID for calls originating from endpoints specified in a FindMe
The provisioning request is challenged by the provisioning server