Cisco Cisco TelePresence Video Communication Server Expressway 릴리즈 노트
New features in X7
Cisco TelePresence Video Communication Server X7.0.1 Software Release Notes
Page 10 of 29
Improved NTP synchronization
The Cisco VCS can now be configured to connect to up to 5 standards-based NTP server addresses.
TMS Agent database credentials included within local authentication
database lookups
database lookups
If the Cisco VCS is enabled for device provisioning (it has the Device Provisioning option key installed
and therefore has a TMS Agent database), then in addition to any manually created entries, the Cisco
VCS now checks credentials stored within that VCS’s TMS Agent database when the device
authentication database type is set to Local database.
and therefore has a TMS Agent database), then in addition to any manually created entries, the Cisco
VCS now checks credentials stored within that VCS’s TMS Agent database when the device
authentication database type is set to Local database.
This makes it easier to enable authentication on the Cisco VCS when provisioning is using passwords
originating from TMS.
originating from TMS.
Other enhancements and usability improvements
You can now configure up to 200 SIP domains.
You can now configure up to 10,000 local authentication database credentials.
Full support of RFC 5806: any SIP diversion headers received in a 302 response are now
maintained in the outgoing INVITE message.
maintained in the outgoing INVITE message.
Improved zone status reporting: the zones summary page now shows separate SIP and H.323
connection status information.
connection status information.
Table sorting indicators: tabular displays now indicate by which column each table is sorted.
A filter facility has been added to the Subzones list page.
Chrome web browser is now supported; Internet Explorer 6 is no longer officially supported.
The administrator no longer has to log out and log back in again after reconfiguring DNS server
addresses.
addresses.
There is a new Call signaling routed mode advanced zone profile setting for neighbor zones. It
controls whether the zone always takes the signaling or uses the system-wide Call routed mode
setting.
controls whether the zone always takes the signaling or uses the system-wide Call routed mode
setting.
There is a new H.323 call signaling port advanced zone profile setting for neighbor zones. It
identifies the call signaling port on the neighbor system to use if Automatically respond to H.323
searches is set to On.
identifies the call signaling port on the neighbor system to use if Automatically respond to H.323
searches is set to On.
SSH and SCP clients are no longer available in the VCS operating system.