Cisco Cisco TelePresence Video Communication Server Expressway 릴리즈 노트
Introduction
Cisco TelePresence Video Communication Server X6.1 Software Release Notes
Page 5 of 26
Introduction
These release notes describe the features and capabilities included in the Cisco TelePresence Video
Communication Server (Cisco VCS) software version X6.1.
Communication Server (Cisco VCS) software version X6.1.
Upgrading to VCS X6.1
WARNING: If you are upgrading a cluster, you must follow the directions in the “VCS Cluster Creation
and Maintenance” deployment guide (document D14367), otherwise the cluster will not synchronize.
and Maintenance” deployment guide (document D14367), otherwise the cluster will not synchronize.
There is a software dependency between VCS X6.n and TMS 12.6 or later. If you are running Cisco
TelePresence Management Suite (Cisco TMS) with Provisioning or FindMe, or your Cisco VCSs are
clustered and you want to upgrade your Cisco VCS to X6.0 or later, you must also upgrade Cisco
TMS to TMS 12.6 or later, see the table below.
TelePresence Management Suite (Cisco TMS) with Provisioning or FindMe, or your Cisco VCSs are
clustered and you want to upgrade your Cisco VCS to X6.0 or later, you must also upgrade Cisco
TMS to TMS 12.6 or later, see the table below.
Deployment using Provisioning, Clustering or FindMe
Software version
TMS 12.1
TMS 12.2
TMS 12.5
TMS 12.6 or later
X4.n
√
√
X
X
X5.0, X5.1.1
X
X
√
X
X5.2
X
X
X
√
X6.n
X
X
X
√
Note: If you are running TMS 12.5 you must upgrade it to 12.6 or later before upgrading to VCS X6.n.
Note: You should backup your system before upgrading. If you later need to downgrade to an earlier
release you will have to restore a backup made against that previous release.
release you will have to restore a backup made against that previous release.
It is vital that you upgrade the Cisco VCS and Cisco TMS correctly – instructions for the upgrade are
documented in the ”Updating to X6” section of this document.
documented in the ”Updating to X6” section of this document.
Upgrading to X6.1 from X5.0 or earlier
If you are currently running VCS X5.0 or earlier you must first upgrade to X5.2 and then upgrade from
X5.2 to X6.1.
X5.2 to X6.1.
You can only upgrade directly to X6.1 if you have version X5.1 or later.
Device authentication: provisioning of Movi and other
devices
devices
Upgrades from release X5.2 or earlier to X6.1
If device authentication is not enabled when the Cisco VCS is upgraded to X6.1, the upgrade process
will configure all zones and subzones (except the default zone) on the Cisco VCS with authentication
set to ‘Treat as authenticated’. This ensures that:
will configure all zones and subzones (except the default zone) on the Cisco VCS with authentication
set to ‘Treat as authenticated’. This ensures that:
CPL continues to work as expected
Caller ID can be set to the FindMe ID for calls originating from endpoints specified in a FindMe
The provisioning request is challenged by the provisioning server
If you are upgrading from X6.0 to X6.1 your existing authentication configuration will not be changed.