Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Field
Description
Usage tips
Pattern type
How the Pattern string must match the alias for
the rule to be applied. Options are:
the rule to be applied. Options are:
Exact: the entire string must exactly match the
alias character for character.
alias character for character.
Prefix: the string must appear at the beginning of
the alias.
the alias.
Suffix: the string must appear at the end of the
alias.
alias.
Applies only if the Type is Alias pattern
match.
Pattern string
The pattern against which the alias is compared.
Applies only if the Type is Alias pattern
match.
Target
subzone
subzone
The subzone to which an endpoint is assigned if its
address satisfies this rule.
address satisfies this rule.
State
Indicates if the rule is enabled or not.
Use this setting to test configuration
changes, or to temporarily disable certain
rules. Any disabled rules still appear in the
rules list but are ignored.
changes, or to temporarily disable certain
rules. Any disabled rules still appear in the
rules list but are ignored.
Applying Bandwidth Limitations to Subzones
You can apply bandwidth limits to the Traversal Subzone as follows:
You can apply bandwidth limits to the Default Subzone, Traversal Subzone and all manually configured subzones.
The limits you can apply vary depending on the type of subzone, as follows:
The limits you can apply vary depending on the type of subzone, as follows:
Limitation
Description
Can be applied to
Total
Limits the total concurrent bandwidth being used by all
endpoints in the subzone at any one time. In the case of the
Traversal Subzone, this is the maximum bandwidth available
for all concurrent traversal calls.
endpoints in the subzone at any one time. In the case of the
Traversal Subzone, this is the maximum bandwidth available
for all concurrent traversal calls.
Default Subzone
Traversal Subzone
Manually configured subzones
Calls entirely
within...
within...
Limits the bandwidth of any individual call between two
endpoints within the subzone.
endpoints within the subzone.
Default Subzone
Manually configured subzones
Calls into or
out of...
out of...
Limits the bandwidth of any individual call between an
endpoint in the subzone, and an endpoint in another subzone
or zone.
endpoint in the subzone, and an endpoint in another subzone
or zone.
Default Subzone
Manually configured subzones
Calls handled
by...
by...
The maximum bandwidth available to any individual traversal
call.
call.
Traversal Subzone
For all the above limitations, the Bandwidth restriction setting has the following effect:
■
No bandwidth: no bandwidth is allocated and therefore no calls can be made.
■
Limited: limits are applied. You must also enter a value in the corresponding bandwidth (kbps) field.
■
Unlimited: no restrictions are applied to the amount of bandwidth being used.
236
Cisco TelePresence Video Communication Server Administrator Guide
Bandwidth Control