Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Using the command line interface (CLI)
The VCS can be configured through a web interface or via a command line interface (CLI).
The CLI is available by default over SSH and through the serial port. These settings are controlled on the
To use the CLI:
1. Start an SSH session.
2. Enter the IP address or FQDN of the VCS.
3. Log in with a username of admin and your system password.
4. You can now start using the CLI by typing the appropriate commands.
Command types
Commands are divided into the following groups:
n
xStatus
: these commands return information about the current status of the system. Information such as
for a full list of xStatus commands.
n
xConfiguration
: these commands allow you to add and edit single items of data such as IP address
commands.
n
xCommand
for a full list of xCommand commands.
n
xHistory
: these commands provide historical information about calls and registrations.
n
xFeedback
: these commands provide information about events as they happen, such as calls and
registrations.
Note that:
n
Typing an xConfiguration path into the CLI returns a list of values currently configured for that element
(and sub-elements where applicable).
(and sub-elements where applicable).
n
Typing an xConfiguration path into the CLI followed by a ? returns information about the usage for that
element and sub-elements.
element and sub-elements.
n
Typing an xCommand command into the CLI with or without a ? returns information about the usage of that
command.
command.
Cisco TelePresence Video Communication Server Administrator Guide (X8.5.1)
Page 20 of 563
Introduction
About this guide