Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Reference material
Cisco VCS Administrator Guide (X7.1)
Page 348 of 479
Restoring default configuration
It is possible to restore the VCS to its default configuration. This is done through the CLI using xCommand
DefaultValuesSet
DefaultValuesSet
. This command is not available through the web interface.
The DefaultValuesSet command allows you to specify the level of configuration to restore, from 1 to 3 as
follows:
follows:
n
Level 1: resets most configuration items to their default value, with the exception of the Level 2 and Level 3
items shown in the tables below.
items shown in the tables below.
n
Level 2: resets configuration items mostly related to remote authentication (listed in Configuration items
reset by DefaultValuesSet level 2), plus Level 1 items to their default values.
reset by DefaultValuesSet level 2), plus Level 1 items to their default values.
n
Level 3: resets all critical configuration items (listed in Configuration items reset by DefaultValuesSet level
3 below) plus Level 1 and Level 2 items to their default values.
3 below) plus Level 1 and Level 2 items to their default values.
See the
section for a full list of all configuration items and, where
applicable, their default values.
Note: xCommand DefaultValuesSet Level: 3 must be used with caution, as it resets the system’s
IPv4 and IPv6 addresses, meaning you will no longer be able to access the system over IP. It also deletes all
option keys including pre-installed options such as Expressway and the number of calls. It also deletes all
links configured on the VCS, including the automatically configured default links between the Default
Subzone, Traversal Subzone and Default Zone. Without these links, calls will not be able to be placed. To
restore these links, you should run the command xCommand DefaultLinksAdd after xCommand
DefaultValuesSet Level: 3
IPv4 and IPv6 addresses, meaning you will no longer be able to access the system over IP. It also deletes all
option keys including pre-installed options such as Expressway and the number of calls. It also deletes all
links configured on the VCS, including the automatically configured default links between the Default
Subzone, Traversal Subzone and Default Zone. Without these links, calls will not be able to be placed. To
restore these links, you should run the command xCommand DefaultLinksAdd after xCommand
DefaultValuesSet Level: 3
. These links can also be restored manually using the web interface - see
the
section for more information.
Configuration items reset by DefaultValuesSet level 3
The following table lists the configuration items that are reset by xCommand DefaultValuesSet
Level: 3
Level: 3
and their reset values.
Configuration item
Reset value
Administration HTTP Mode
On
Administration HTTPS Mode
On
Administration SSH Mode
On
Administration Telnet Mode
Off
Ethernet [1..2] IP V4 Address
192.168.0.100
Ethernet [1..2] IP V4 StaticNAT Address
<blank>
Ethernet [1..2] IP V4 StaticNAT Mode
Off
Ethernet [1..2] IP V4 SubnetMask
255.255.255.0
Ethernet [1..2] IP V6 Address
<blank>
Ethernet [1..2] Speed
Auto
IPProtocol
IPv4