Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Dial plan and call processing
Cisco VCS Administrator Guide (X7.0)
Page 156 of 488
Dial plan configuration
The
Dial plan configuration
page (
VCS configuration > Dial plan> Configuration
) is used to
configure how the VCS routes calls in specific call scenarios.
The configurable options are:
Field
Description
Usage tips
Calls to
unknown
IP
addresses
unknown
IP
addresses
Determines the way in which the VCS
attempts to call systems which are not
registered with it or one of its neighbors.
attempts to call systems which are not
registered with it or one of its neighbors.
Direct: allows an endpoint to make a call to
an unknown IP address without the VCS
querying any neighbors.
The call setup would occur just as it would if
the far end were registered directly to the
local system.
an unknown IP address without the VCS
querying any neighbors.
The call setup would occur just as it would if
the far end were registered directly to the
local system.
Indirect: upon receiving a call to an unknown
IP address, the VCS will query its neighbors
for the remote address and if permitted will
route the call through the neighbor.
IP address, the VCS will query its neighbors
for the remote address and if permitted will
route the call through the neighbor.
Off: endpoints registered directly to the VCS
may only call an IP address of a system also
registered directly to that VCS.
may only call an IP address of a system also
registered directly to that VCS.
The default is Indirect.
This setting applies to the call's destination
address prior to any zone transforms, but after
any pre-search transforms, Call Policy or User
Policy rules have been applied.
address prior to any zone transforms, but after
any pre-search transforms, Call Policy or User
Policy rules have been applied.
In addition to controlling calls, this setting also
determines the behavior of provisioning and
presence messages to SIP devices, as these
messages are routed to IP addresses.
determines the behavior of provisioning and
presence messages to SIP devices, as these
messages are routed to IP addresses.
See the
section for more information.
Fallback
alias
alias
The alias to which incoming calls are placed
for calls where the IP address or domain
name of the VCS has been given but no
callee alias has been specified.
for calls where the IP address or domain
name of the VCS has been given but no
callee alias has been specified.
If no fallback alias is configured, calls that do
not specify an alias will be disconnected. See
below for more information.
not specify an alias will be disconnected. See
below for more information.
About the fallback alias
The VCS could receive a call that is destined for it but which does not specify an alias. This could be for
one of the following reasons:
one of the following reasons:
n
the caller has dialed the IP address of the VCS directly
n
the caller has dialed a domain name belonging to the VCS (either one of its configured SIP domains, or
any domain that has an SRV record that points at the IP address of the VCS), without giving an alias
as a prefix
any domain that has an SRV record that points at the IP address of the VCS), without giving an alias
as a prefix
Normally such calls would be disconnected. However, such calls will be routed to the Fallback alias if it
is specified.
is specified.
Note that some endpoints do not allow users to enter an alias and an IP address to which the call should
be placed.
be placed.