Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Firewall traversal
Cisco VCS Administrator Guide (X7.0)
Page 229 of 488
Ports for initial connections from traversal clients
Each traversal server zone specifies an H.323 port and a SIP port to be used for the initial connection
from the client.
from the client.
Each time you configure a new traversal server zone on the VCS Expressway, you are allocated default
port numbers for these connections:
port numbers for these connections:
n
H.323 ports start at UDP/6001 and increment by 1 for every new traversal server zone.
n
SIP ports start at TCP/7001 and increment by 1 for every new traversal server zone.
You can change these default ports if necessary but you must ensure that the ports are unique for each
traversal server zone.
traversal server zone.
After the H.323 and SIP ports have been set on the VCS Expressway, matching ports must be
configured on the corresponding traversal client.
configured on the corresponding traversal client.
Note:
n
The default port used for the initial connections from MXP endpoints is the same as that used for
standard RAS messages, that is UDP/1719. While it is possible to change this port on the VCS
Expressway, most endpoints will not support connections to ports other than UDP/1719. You are
therefore recommended to leave this as the default.
standard RAS messages, that is UDP/1719. While it is possible to change this port on the VCS
Expressway, most endpoints will not support connections to ports other than UDP/1719. You are
therefore recommended to leave this as the default.
n
You must allow outbound connections through your firewall to each of the unique SIP and H.323 ports
that are configured on each of the VCS Expressway’s traversal server zones.
that are configured on each of the VCS Expressway’s traversal server zones.
Default port summary
The following table shows the default ports used for connections to the VCS Expressway.
Protocol
Call signaling
Media
Assent
UDP/1719: listening port for RAS
messages
messages
TCP/2776: listening port for H.225 and
H.245 protocols
H.245 protocols
UDP/2776: RTP media port
UDP/2777: RTCP media control port
H.460.18/19 UDP/1719: listening port for RAS
messages
TCP/1720: listening port for H.225
protocol
protocol
TCP/2777: listening port for H.245
protocol
protocol
UDP/2776: RTP media port
UDP/2777: RTCP media control port
UDP/50000-52399: demultiplex media port range
SIP
SIP call signaling uses the same port as
used by the initial connection between
the client and server.
used by the initial connection between
the client and server.
Where the traversal client is a VCS, SIP media
uses Assent to traverse the firewall. The default
ports are the same as for H.323:
uses Assent to traverse the firewall. The default
ports are the same as for H.323:
UDP/2776: RTP media port
UDP/2777: RTCP media control port