Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Dial plan and call processing
Field
Description
Usage tips
State
Indicates if the rule is enabled or not.
When you are making or testing
configuration changes to your Cisco
AM GW policy rules, you may want to
temporarily enable or disable certain
rules. You may also want to configure
certain rules but only apply them
occasionally. You can do this by
selecting the rule's check box and
clicking Enable or Disable as
appropriate. Any disabled rules still
appear in the rules list but are ignored
by the Cisco VCS when determining
which calls are routed via the Cisco
AM GW.
configuration changes to your Cisco
AM GW policy rules, you may want to
temporarily enable or disable certain
rules. You may also want to configure
certain rules but only apply them
occasionally. You can do this by
selecting the rule's check box and
clicking Enable or Disable as
appropriate. Any disabled rules still
appear in the rules list but are ignored
by the Cisco VCS when determining
which calls are routed via the Cisco
AM GW.
Dialable address formats
The destination address that is entered using the caller’s endpoint can take a number of different
formats, and this affects the specific process that the Cisco VCS follows when attempting to locate
the destination endpoint. The address formats supported by the Cisco VCS are:
formats, and this affects the specific process that the Cisco VCS follows when attempting to locate
the destination endpoint. The address formats supported by the Cisco VCS are:
n
IP address, for example 10.44.10.1 or 3ffe:80ee:3706::10:35
n
H.323 ID, for example john.smith or john.smith@example.com (note that an H.323 ID can be in
the form of a URI)
the form of a URI)
n
E.164 alias, for example 441189876432 or 6432
n
URI, for example john.smith@example.com
n
ENUM, for example 441189876432 or 6432
Each of these address formats may require some configuration of the Cisco VCS in order for them to
be supported. These configuration requirements are described below.
be supported. These configuration requirements are described below.
Dialing by IP address
Dialing by IP address is necessary when the destination endpoint is not registered with any system
(such as a Cisco VCS, gatekeeper or Border Controller). See the
(such as a Cisco VCS, gatekeeper or Border Controller). See the
section for more
information.
Endpoints registered to a Cisco VCS Expressway
Calls made by dialing the IP address of an H.323 endpoint registered directly with a Cisco VCS
Expressway are forced to route through the Cisco VCS Expressway. The call will therefore be subject
to any restrictions configured on that system.
Expressway are forced to route through the Cisco VCS Expressway. The call will therefore be subject
to any restrictions configured on that system.
Dialing by H.323 ID or E.164 alias
No special configuration is required to place a call using an H.323 ID or E.164 alias.
The Cisco VCS follows the usual
, applying any transforms and then searching the
Local Zone and external zones for the alias, according to the search rules.
Note: SIP endpoints always register using an AOR in the form of a URI. You are recommended to
ensure that H.323 endpoints also register with an H.323 ID in the form of a URI to facilitate
interworking.
ensure that H.323 endpoints also register with an H.323 ID in the form of a URI to facilitate
interworking.
Cisco VCS Administrator Guide (X6)
Page 137 of 295