Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Reference material
CPL reference
Call Processing Language (CPL) is an XML-based language for defining call handling. This section
gives details of the VCS’s implementation of the CPL language and should be read in conjunction with
the CPL standard RFC 3880 [
gives details of the VCS’s implementation of the CPL language and should be read in conjunction with
the CPL standard RFC 3880 [
] and the Guide to writing CPL [
].
The VCS has many powerful inbuilt transform features so CPL should be required only if advanced call
handling rules are required.
handling rules are required.
The VCS supports most of the CPL standard along with some TANDBERG-defined extensions. It
does not support the top level actions <incoming> and <outgoing> as described in RFC 3880.
Instead it supports a single section of CPL within a <taa:routed> section.
does not support the top level actions <incoming> and <outgoing> as described in RFC 3880.
Instead it supports a single section of CPL within a <taa:routed> section.
When Call Policy is implemented by uploading a CPL script to the VCS, the script is checked against
an XML schema to verify the syntax. There are two schemas - one for the basic CPL specification and
one for the TANDBERG extensions. Both of these schemas can be
an XML schema to verify the syntax. There are two schemas - one for the basic CPL specification and
one for the TANDBERG extensions. Both of these schemas can be
and used to validate your script before uploading to the VCS.
The following example shows the correct use of namespaces to make the syntax acceptable:
<?xml version="1.0" encoding="UTF-8" ?>
<cpl xmlns="urn:ietf:params:xml:ns:cpl"
xmlns:taa="http://www.tandberg.net/cpl-extensions"
xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance"
xsi:schemaLocation="urn:ietf:params:xml:ns:cpl cpl.xsd">
<taa:routed>
<address-switch field="destination">
<address is="reception@example.com">
<proxy/>
</address>
</address-switch>
</taa:routed>
</cpl>
CPL address-switch node
The address-switch node allows the script to run different actions based on the source or
destination aliases of the call. It specifies which fields to match, and then a list of address nodes
contains the possible matches and their associated actions.
destination aliases of the call. It specifies which fields to match, and then a list of address nodes
contains the possible matches and their associated actions.
The address-switch has two node parameters: field and subfield.
address
The address construct is used within an address-switch to specify addresses to match. It
supports the use of
supports the use of
Valid values are:
is=string
Selected field and subfield exactly match the given string.
Cisco VCS Administrator Guide (X6.1)
Page 244 of 401