Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
Network and system settings
See the
section for a complete list of all events that are logged by the VCS, and the
level at which they are logged.
You can control which events are logged by the VCS by setting the Log level. All events with a level
numerically equal to and lower than the specified logging level are recorded in the Event Log. So, at
level 1, only level 1 events are logged; at level 2, both level 1 and level 2 events are logged, and so on.
The default log level is 1.
numerically equal to and lower than the specified logging level are recorded in the Event Log. So, at
level 1, only level 1 events are logged; at level 2, both level 1 and level 2 events are logged, and so on.
The default log level is 1.
Note that:
n
Logging at level 3 or level 4 is not usually recommended as the Event Log holds a maximum of 2GB
of data and logging at these levels on a busy system could cause the Event Log to be recycled too
quickly.
of data and logging at these levels on a busy system could cause the Event Log to be recycled too
quickly.
n
Changes to the event log level affect both the Event Log that you can view via the web interface,
and the information that is copied to the remote log server (if any) that you have configured.
and the information that is copied to the remote log server (if any) that you have configured.
n
Changes to the event log level are not retrospective. If you change the event log level, it will only
effect what is logged from that point onwards.
effect what is logged from that point onwards.
Remote logging
The Event Log is always stored locally on the VCS. However, it is often convenient to collect copies
of all event logs from various systems in a single location. A computer running a BSD-style syslog
server, as defined in RFC 3164 [
of all event logs from various systems in a single location. A computer running a BSD-style syslog
server, as defined in RFC 3164 [
], may be used as the central log server. Note that:
n
A VCS will not act as a central logging server for other systems.
n
Events are always logged locally (to the Event Log) regardless of whether or not remote logging is
enabled.
enabled.
n
The VCS may use any of the 23 available syslog facilities for different messages. Specifically,
LOCAL0..LOCAL7 (facilities 16..23) are used by different components of the application software
on the VCS.
LOCAL0..LOCAL7 (facilities 16..23) are used by different components of the application software
on the VCS.
To enable remote logging, you must configure the VCS with the IP addresses or Fully Qualified
Domain Names (FQDNs) of the Remote syslog servers to where the Event Log is written. Up to 4
servers can be specified. Note that these servers cannot be another VCS.
Domain Names (FQDNs) of the Remote syslog servers to where the Event Log is written. Up to 4
servers can be specified. Note that these servers cannot be another VCS.
Cisco VCS Administrator Guide (X6.1)
Page 55 of 401