Cisco Cisco Web Security Appliance S170 사용자 가이드

You can configure SNMP traps (enable or disable specific traps) when you enable SNMP for an 
interface. To specify multiple trap targets: when prompted for the trap target, you may enter up to 10 
comma separated IP addresses.

In this example, the 

snmpconfig

 command is used to enable SNMP on the “PublicNet” interface on port 

161. A passphrase for version 3 is entered and then re-entered for confirmation. The system is configured 
to service version 1 and 2 requests, and the community string 

public

 is entered for GET requests from 

those versions 1 and 2. The trap target of 

10.1.1.29

 is entered. Finally, system location and contact 

information is entered.

example.com> snmpconfig

Current SNMP settings:

SNMP Disabled.

Choose the operation you want to perform:

- SETUP - Configure SNMP.

[]> setup

Do you want to enable SNMP? [N]> y

Please choose an IP interface for SNMP requests.

1. Management (192.168.1.1/24: wsa01-vmw1-tpub.qa)

[1]>

Enter the SNMPv3 passphrase.

>

Please enter the SNMPv3 passphrase again to confirm.

>

Which port shall the SNMP daemon listen on?

[161]>

Service SNMP V1/V2c requests? [N]> y