Cisco Cisco Web Security Appliance S170 사용자 가이드
2-7
AsyncOS 9.1 for Cisco Web Security Appliances User Guide
Chapter 2 Connect, Install, and Configure
System Setup Wizard
Network / Network Interfaces and Wiring
The IP address, network mask, and host name to use to manage the Web Security appliance and, by
default, for proxy (data) traffic.
default, for proxy (data) traffic.
You can use the host name specified here when connecting to the appliance management interface (or in
browser proxy settings if M1 is used for proxy data), but you must register it in your organization’s DNS.
browser proxy settings if M1 is used for proxy data), but you must register it in your organization’s DNS.
NTP Server
The Network Time Protocol (NTP) server used to synchronize the system
clock with other servers on the network or the Internet.
clock with other servers on the network or the Internet.
The default is time.sco.cisco.com.
Time Zone
Provide time-zone information for location of the appliance; affects
timestamps in message headers and log files.
timestamps in message headers and log files.
Appliance Mode
of Operation
of Operation
•
Standard – Used for standard on-premise policy enforcement.
•
Cloud Web Security Connector – Used primarily to direct traffic to Cisco’s
Cloud Web Security service for policy enforcement and threat defense.
Cloud Web Security service for policy enforcement and threat defense.
•
for more information about
these modes of operation.
Property
Description
Setting
Description
Ethernet Port
(Optional) Check Use M1 port for management only if you want to use a separate
port for data traffic.
port for data traffic.
If you configure the M1 interface for management traffic only, you must configure
the P1 interface for data traffic. You must also define different routes for
management and data traffic. However, you can configure the P1 interface even
when the M1 interface is used for both management and data traffic.
the P1 interface for data traffic. You must also define different routes for
management and data traffic. However, you can configure the P1 interface even
when the M1 interface is used for both management and data traffic.
You can enable and configure the P1 port only in the System Setup Wizard. If
you want to enable the P2 interface, you must do this after finishing the System
Setup Wizard.
you want to enable the P2 interface, you must do this after finishing the System
Setup Wizard.
IP Address /
Netmask
Netmask
The IP address and network mask to use when managing the Web Security appliance
on this network interface.
on this network interface.
Hostname
The host name to use when managing the Web Security appliance on this
network interface.
network interface.