Cisco Cisco TelePresence MX700 관리 매뉴얼

D14850.07 MX Series Administrator Guide TC6.3, OCTOBER 2013.

Cisco TelePresence MX Series

Administrator Guide

Conference settings

Conference [1..1] CallProtocolIPStack

Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).

Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>

Dual: Enables both IPv4 and IPv6 for H323 and SIP calls.
IPv4: When set to IPv4, the call protocol (SIP, H323) will use IPv4.
IPv6: When set to IPv6, the call protocol (SIP, H323) will use IPv6.

Example:

Conference 1 CallProtocolIPStack: Dual

Conference [1..1] TelephonyPrefix

Enter the prefix to be used for telephony calls.

Requires user role: ADMIN
Value space: <S: 0, 80>

Format: String with a maximum of 80 characters.

Example:

Conference 1 TelephonyPrefix: "520"

Conference [1..1] AutoAnswer Mode

Set the auto answer mode.

Requires user role: ADMIN
Value space: <Off/On>

Off: An incoming call must be answered manually by tapping the Accept key on the Touch

controller.
On: Enable auto answer to let the system automatically answer all incoming calls.

Example:

Conference 1 AutoAnswer Mode: Off

Conference [1..1] AutoAnswer Mute

Determine if the microphone shall be muted when an incoming call is automatically answered.

NOTE: Requires that AutoAnswer Mode is switched on.

Requires user role: ADMIN
Value space: <Off/On>

Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.

Example:

Conference 1 AutoAnswer Mute: Off

Conference [1..1] AutoAnswer Delay

Define how long (in seconds) an incoming call has to wait before it is answered automatically by

the system. NOTE: Requires that AutoAnswer Mode is switched on.

Requires user role: ADMIN
Value space: <0..50>

Range: Select a value from 0 to 50 seconds.

Example:

Conference 1 AutoAnswer Delay: 0

Conference [1..1] MicUnmuteOnDisconnect Mode

Determine if the microphones shall be unmuted automatically when all calls are disconnected.

In a meeting room or other shared resources this may be done to prepare the system for the

next user.

Requires user role: ADMIN
Value space: <Off/On>

Off: If muted during a call, let the microphones remain muted after the call is disconnected.
On: Unmute the microphones after the call is disconnected.

Example:

Conference 1 MicUnmuteOnDisconnect Mode: On

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings