Cisco Cisco Cius 4G 디자인 가이드
Cisco Cius Wireless Deployment Guide
68
This may be necessary if there is an intermittent interferer present in an area.
The channel width can be configured for 20 MHz or 40 MHz if using Cisco 802.11n Access Points.
It is recommended to use 40 MHz channels only if using 5 GHz.
The channel width can be configured for 20 MHz or 40 MHz if using Cisco 802.11n Access Points.
It is recommended to use 40 MHz channels only if using 5 GHz.
Client Roaming
Cisco Cius does not utilize the RF parameters in the Client Roaming section of the Cisco Unified Wireless LAN Controller as
scanning and roaming is managed independently by the phone itself.
scanning and roaming is managed independently by the phone itself.
Call Admission Control
Cisco Cius currently does not support TSPEC (Call Admission Control).
Call Admission Control (TSPEC) for voice should only be enabled if other TSPEC capable clients are using the same band
frequency; TSPEC for video should not be enabled.
If Admission Control Mandatory (ACM) is enabled for Voice, Cisco Cius will be required to downgrade the priority of the
audio packets sent upstream from UP6 (voice) to a lower priority (UP5 video) for an audio only call.
Call Admission Control (TSPEC) for voice should only be enabled if other TSPEC capable clients are using the same band
frequency; TSPEC for video should not be enabled.
If Admission Control Mandatory (ACM) is enabled for Voice, Cisco Cius will be required to downgrade the priority of the
audio packets sent upstream from UP6 (voice) to a lower priority (UP5 video) for an audio only call.
If Call Admission Control for voice is to be enabled, then configure maximum bandwidth and reserved roaming bandwidth
percentages for either 5 or 2.4 GHz depending on which band is to be utilized.
The maximum bandwidth default setting for voice is 75% where 6% of that bandwidth is reserved for roaming clients.
Roaming clients are not limited to using the reserved roaming bandwidth, but roaming bandwidth is to reserve some bandwidth
for roaming clients in case all other bandwidth is utilized.
percentages for either 5 or 2.4 GHz depending on which band is to be utilized.
The maximum bandwidth default setting for voice is 75% where 6% of that bandwidth is reserved for roaming clients.
Roaming clients are not limited to using the reserved roaming bandwidth, but roaming bandwidth is to reserve some bandwidth
for roaming clients in case all other bandwidth is utilized.
If CAC is to be enabled, will want to ensure Load-based CAC is enabled, which is available for the Cisco Unified Wireless
LAN Controller, but not currently available on the Cisco Autonomous Access Point platform.
Load-based CAC will account for non-TSPEC clients as well as all other energy on the channel.
Since TSPEC is not supported currently, SIP CAC can be utilized, which will require media session snooping to be enabled on
the WLAN / SSID.
Traffic Stream Metrics (TSM) is not supported as this feature requires TSPEC support, but can be enabled if other capable
clients are utilizing the same band frequency.
LAN Controller, but not currently available on the Cisco Autonomous Access Point platform.
Load-based CAC will account for non-TSPEC clients as well as all other energy on the channel.
Since TSPEC is not supported currently, SIP CAC can be utilized, which will require media session snooping to be enabled on
the WLAN / SSID.
Traffic Stream Metrics (TSM) is not supported as this feature requires TSPEC support, but can be enabled if other capable
clients are utilizing the same band frequency.