Cisco Cisco Firepower Management Center 2000 문제 해결 가이드
Document ID: 118626
Updated: Dec 03, 2015
Contributed by Nazmul Rajib, Cisco TAC Engineer.
Related Products
●
●
●
●
Contents
IntroductionPrerequisitesSymptomsTroubleshootingStep 1: Verify NTP ConfigurationStep 2: Identify a Timeserver and It's StatusStep 3: Verify ConnectivityStep 4: Verify Configuration FilesRelated Cisco Support Community Discussions
Introduction
You can choose to synchronize time between your FireSIGHT Systems in three different ways,
such as manually, using external NTP servers, or using FireSIGHT Management Center (serving
as an NTP server). You can configure a FireSIGHT Management Center as a time server using
NTP and then use it to synchronize time between the FireSIGHT Management Center and
managed devices. This document describes common issues with time synchronization on
FireSIGHT Systems and how to troubleshoot them.
such as manually, using external NTP servers, or using FireSIGHT Management Center (serving
as an NTP server). You can configure a FireSIGHT Management Center as a time server using
NTP and then use it to synchronize time between the FireSIGHT Management Center and
managed devices. This document describes common issues with time synchronization on
FireSIGHT Systems and how to troubleshoot them.
Prerequisites
In order to configure the time synchronization setting, you need
admin
level of access on your
FireSIGHT Management Center.
Note: The information in this document was created from the devices in a specific lab
environment. All of the devices used in this document started with a cleared (default)
configuration. If your network is live, make sure that you understand the potential impact of
any command.
environment. All of the devices used in this document started with a cleared (default)
configuration. If your network is live, make sure that you understand the potential impact of
any command.