Cisco Cisco Firepower Management Center 2000 기술 매뉴얼
Contents
Introduction
Prerequisites
Requirements
Components Used
Configuration
Adding a Cluster
Breaking a Cluster
Sharing the State
Troubleshooting
Device is not Properly Configured
All HA Members Must Have Up-to-date Policies
Related Documents
Related Cisco Support Community Discussions
Introduction
Clustering of device provides redundancy of configuration and networking functionality between
two devices or stacks. This article describes how to configure clustering on Cisco Firepower 7000
and 8000 series devices.
two devices or stacks. This article describes how to configure clustering on Cisco Firepower 7000
and 8000 series devices.
Prerequisites
Before you attempt to establish a cluster, you must be familiar with various features of clustering.
Cisco recommends you to read the
Cisco recommends you to read the
Guide for more information.
Requirements
Both devices must have the following identical components:
Same hardware models
Note: A stack and a single device cannot be configured in a cluster. They must be in stack of
the same type or two similar single devices.
Note: A stack and a single device cannot be configured in a cluster. They must be in stack of
the same type or two similar single devices.
1.
S
Note: Stacking netmods are not taken into consideration when the prerequisites of cluster
are checked. They are considered the same as an empty slot.
Note: Stacking netmods are not taken into consideration when the prerequisites of cluster
are checked. They are considered the same as an empty slot.
2.
Same licenses and they must be exactly the same. If one device has an additional license,
the cluster cannot be formed.
the cluster cannot be formed.
3.
Same software versions
4.
Same VDB versions
5.
Same NAT policy (If configured)
6.
Components Used