Cisco Cisco Firepower Management Center 2000 정보 가이드
Cisco Systems, Inc.
www.cisco.com
www.cisco.com
78-100731-01A0
Installing Round Hole Adapters for Square Hole
Rack Slides for the Cisco Firepower 8000 Series
Rack Slides for the Cisco Firepower 8000 Series
Last Updated: May 27, 2015
This document describes how to install round hole rack adapters that can be used to adapt the
square-hole-only sliding rail kits that are supplied with the Cisco Firepower 8000 Series devices. The
document contains the following sections:
square-hole-only sliding rail kits that are supplied with the Cisco Firepower 8000 Series devices. The
document contains the following sections:
•
•
•
•
Warning
This document applies only to sliding rail kits that have yellow square hole mount retention pieces.
Use with other racks and slides is not supported and may cause injury or damage to equipment.
Use with other racks and slides is not supported and may cause injury or damage to equipment.
Supplied Components
The adapter kit in
contains all items needed to adapt one sliding rail kit needed to mount one
Firepower 8000 Series 1U or 2U device in a rack. Your kit should look similar to the kit in
.
Table 1
Round-to-Square Hole Rack Adapter Kit for Firepower 8000 Devices
Adapter Kit
Contents
FP8000-RND-ADPT=
4 x adapter brackets
8 x 10-32 x ¼” (6.35mm) Philips pan head screws
4 x M5-0.8mm x 15mm Philips pan head screws
4 x M5 flat washer – optional
4 x M5 lock washer – optional