Cisco Cisco Firepower Management Center 2000 문제 해결 가이드
Document ID: 118481
Updated: Sep 17, 2015
Contributed by Nazmul Rajib, Cisco TAC Engineer.
Related Products
●
●
●
Contents
Introduction1-Second Performance MonitorEnable On Version 5.4 or LaterEnable On Versions Prior to 5.4Related DocumentsRelated Cisco Support Community Discussions
Introduction
On an appliance running Sourcefire software, you can configure the basic parameters that monitor
and report on its own performance. The performance statistic is critical to troubleshoot
performance related issues on an appliance running Snort. This document provides the steps to
enable this feature using a FireSIGHT Management Center.
and report on its own performance. The performance statistic is critical to troubleshoot
performance related issues on an appliance running Snort. This document provides the steps to
enable this feature using a FireSIGHT Management Center.
Warning: If your network is live and you enable 1-Second Performance on a production
system, it can impact network performance. You should enable this only if this is requested
by Cisco Technical Support for troubleshooting purpose.
system, it can impact network performance. You should enable this only if this is requested
by Cisco Technical Support for troubleshooting purpose.
Note: The information in this document was created from the devices in a specific lab
environment. All of the devices used in this document started with a cleared (default)
configuration.
environment. All of the devices used in this document started with a cleared (default)
configuration.
1-Second Performance Monitor
The 1-Second Performance Monitor feature allows you to specify the intervals at which the system
updates performance statistics on your devices by configuring the following:
updates performance statistics on your devices by configuring the following: