Cisco Cisco IOS Software Release 12.2(33)SXH
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2007 Cisco Systems, Inc. All rights reserved.
MSDP Compliance with IETF RFC 3618
The MSDP Compliance with IETF RFC 3618 feature enables you to configure Multicast Source
Discovery Protocol (MSDP) to comply with the peer-RPF forwarding rules defined in the Internet
Engineering Task Force (IETF) RFC 3618 specifications. Enabling the MSDP Compliance with IETF
RFC 3618 feature prevents Source-Active (SA) message loops. Additionally, enabling the MSDP
Compliance with IETF RFC 3618 feature eliminates the requirement that Border Gateway Protocol
(BGP) route reflectors (RRs) run MSDP, enables the use of an Interior Gateway Protocol (IGP) for the
Reverse Path Forwarding (RPF) check, and allows MSDP peerings between routers in nondirectly
connected autonomous systems.
Discovery Protocol (MSDP) to comply with the peer-RPF forwarding rules defined in the Internet
Engineering Task Force (IETF) RFC 3618 specifications. Enabling the MSDP Compliance with IETF
RFC 3618 feature prevents Source-Active (SA) message loops. Additionally, enabling the MSDP
Compliance with IETF RFC 3618 feature eliminates the requirement that Border Gateway Protocol
(BGP) route reflectors (RRs) run MSDP, enables the use of an Interior Gateway Protocol (IGP) for the
Reverse Path Forwarding (RPF) check, and allows MSDP peerings between routers in nondirectly
connected autonomous systems.
Configuration Information
Configuration information is included in the “Using MSDP to Interconnect Multiple PIM-SM Domains”
module at the following URL:
module at the following URL:
The following sections provide information about this feature:
•
Configuring MSDP Compliance with IETF RFC 3618
•
MSDP Compliance with IETF RFC 3618: Example
For a complete list of features included in the “Using MSDP to Interconnect Multiple PIM-SM
Domains” module, see the Feature Information table located toward the end of the module.
Domains” module, see the Feature Information table located toward the end of the module.
Command Reference Information
Release 12.2SX
The following commands are new or modified for this feature:
•
ip msdp rpf rfc3618
•
show ip msdp rpf-peer