Cisco Cisco IOS XE 3.5E 릴리즈 노트
Release Notes for the Catalyst 3850 Series Switches, Cisco IOS XE Release 3.3.xSE
OL-30562-05
Important Notes
Important Notes
•
Although visible in the CLI, the following commands are not supported:
–
switchport mode dot1qtunnel
–
collect flow username
–
authorize-lsc-ap (CSCui93659)
–
show platform qos xxx (CSCug09112)
•
WCCPv2 is supported for egress IPv4 traffic with the following limitations and restrictions:
–
Load balancing using only mask assignments; no support for hash assignments in hardware.
–
No VRF-aware WCCP support.
–
No IPv6 WCCP support.
–
Either PBR or WCCP configuration is supported on an interface.
–
Maximum number of service groups is eight for ingress and eight for egress.
•
The following features are not supported in Cisco IOS XE Release 3.3.0SE:
–
Outdoor Access Points
–
Mesh, FlexConnect, and Office Extend Access Point deployment
–
Wireless Guest Anchor Controller (The Catalyst 3850 switch can be configured as a foreign controller.)
–
IPv6 Multicast Routing
–
Resilient Ethernet Protocol
–
Virtual Router Redundancy Protocol (VRRP)
–
Private VLANs
–
Device Sensor
–
MVR (Multicast VLAN Registration)
–
EnergyWise
–
IPv6 routing - OSPFv3 Authentication
–
Call Home
–
DVMRP Tunneling
–
Port Security on EtherChannel
–
802.1x Configurable username and password for MAB
–
Government Certificates: Common Criteria & FIPS
–
Link State Tracking (L2 Trunk Failover)
–
Disable Per VLAN MAC Learning
–
IEEE 802.1X-2010 with 802.1AE support
–
IEEE 802.1AE MACsec (MKA & SAP)
–
Command Switch Redundancy
–
CNS Config Agent
–
Dynamic Access Ports
–
IPv6 Ready Logo phase II - Host