Cisco Cisco IPS 4255 Sensor 릴리즈 노트

Once you have downloaded the password recovery image file, follow the instructions to install the 
system image file but substitute the password recovery image file for the system image file. The IDSM2 
should reboot in to the primary partition after installing the recovery image file. If it does not, enter the 
following command from the switch:

The password is reset to cisco. Log in to the CLI with username cisco and password cisco. You can then 
change the password.

For the procedure for installing system images on the IDSM2, refer to 

For more information on downloading Cisco IPS software, see 

.

You can reset the password to the default (cisco) for the AIP SSM using the CLI or the ASDM. Resetting 
the password causes it to reboot. IPS services are not available during a reboot.

To reset the password, you must have ASA 7.2.2 or later. 

Use the hw-module module slot_number password-reset command to reset the password to the default 
cisco. If the module in the specified slot has an IPS version that does not support password recovery, the 
following error message is displayed:

ERROR: the module in slot <n> does not support password recovery.

To reset the password on the AIP SSM, follow these steps:

Log into the adaptive security appliance and enter the following command to verify the module slot 
number:

asa# show module

Mod Card Type                                    Model              Serial No.

--- -------------------------------------------- ------------------ -----------

  0 ASA 5510 Adaptive Security Appliance         ASA5510            JMX1135L097

  1 ASA 5500 Series Security Services Module-40  ASA-SSM-40         JAF1214AMRL

Mod MAC Address Range                 Hw Version   Fw Version   Sw Version

--- --------------------------------- ------------ ------------ ---------------

  0 001b.d5e8.e0c8 to 001b.d5e8.e0cc  2.0          1.0(11)2     8.4(3)

  1 001e.f737.205f to 001e.f737.205f  1.0          1.0(14)5     7.0(7)E4

Mod SSM Application Name           Status           SSM Application Version

--- ------------------------------ ---------------- --------------------------

  1 IPS                            Up               7.0(7)E4

Mod Status             Data Plane Status     Compatibility

--- ------------------ --------------------- -------------

  0 Up Sys             Not Applicable

  1 Up                 Up